Demineralizer; Set Of Demineralizer System - Tecno-gaz HYDRA Instrucciones De Uso

ENGLISH
15

15.1 Set of demineralizer system

Autoclave is already prepared also for plug IONIC SYSTEM or OSMOSI SYSTEM for
charging water into the autoclave (optional accessories).
These applications are accessories of autoclave.
These applications have been designed for remove minerals in the water before to charge
the autoclave.
First to plug the hydraulic connections it is necessary set the software of autoclave following
this instructions
.
1. Switch-on the autoclave with the MAINS (FIG.2–POS.
B-START ((during the switch on) until you see a string reporting the selected language.
2. Press and release
 CHARGING BY PUMP
 IONIC SYSTEM
 OSMOSI SYSTEM
3. To change this setting use B-SELECT.
4. To save keep pressed
5. To exit keep pressed
Set data are stored in memory.
WARNING
The number you can see on display, under the kind of water system used, it's a counter. It
gives you an indication about the number of cycles possible to make until the end of filter (in
case of osmosis system) or until the end of resins (in case of ionic system).
When you change the filter or the resins, it's necessary reset the number of the counter after
saving of the kind of system used.
For reset the counter it's necessary keep push the button
of the buzzer (it takes about 10 second) in the main page of the menu where you can start
the sterilization cycle.
30

DEMINERALIZER

B-START to select next screen until you setting the water load:
B-DOOR until you hear a "BEEP".
B-START until you hear a "BEEP".
17 ) switch and keep pressed
B-PUMP until the acoustic signal