American Standard Townsend 0330 Instrucciones De Instalación

INSTALLATION INSTRUCTIONS
Undercounter Sink
0330 Townsend
Introduction: Thank you for selecting our products...products which have been the benchmarks of fine quality for years. To help
ensure that the installation process will proceed smoothly, please read these instructions carefully before you begin. Also, review
the recommended tools and materials list; carefully unpack and examine your new plumbing fixture.
CAUTION: PRODUCT IS FRAGILE. TO AVOID BREAKAGE AND POSSIBLE INJURY HANDLE WITH CARE!
!
NOTE: Pictures may not exactly define contour of china and components.
Observe Local Plumbing and Building Codes.
Product names listed herein are trademarks of American Standard Inc. unless otherwise noted.
Recommended Tools & Materials
Putty Knife Adjustable Wrench
Pipe Wrench
Drill
1
NOTE: To avoid damage to
countertop, install sink such that
future removal from underneath
the countertop is possible.
First, make sure the clearance
between the backsplash, faucet,
fixtures and cabinets are
acceptable for the new sink.
2
Carefully cut out the enclosed template, then position and trace
the template on the countertop as shown on the template.
Make a mark of the faucet hole centerline on the countertop.
Drill a 1/2" pilot hole on the inside of the cut line. Use a saber
saw or a keyhole saw to cut out the countertop opening.
PERIMETER OF SINK
CUTOUT
Rectangle
®
Plumbers' Putty
Basin Wrench
Tubing Cutter
NOTE: More specialized tools may be necessary to install this sink
to countertop materials other than wood or wood composites.
Saber Saw
Product names listed herein are trademarks of AS America, Inc.
© AS America, Inc. 2017
Silicone Adhesive
Channel Lock Pliers
Phillips Screwdriver Regular Screwdriver
3
FOR WOOD COUNTERTOP
Mark and pre-drill the wood screw holes as located on the
enclosed template. Waterproof any exposed areas of wood.
Drill 1/8 dia. x 3/8 deep
#10 Wood Screw
4
FOR MARBLE OR SOLID SURFACE COUNTERTOP
To protect countertop, place it on a foam padding
and drill 3/8 Dia. x 1/2 deep hole as per location
shown on template.
1/2 MIN.
Tape Measure
Hacksaw
1/2 MIN.
Clip
Brass insert, epoxy in place
with threaded end exposed.
(Epoxy not supplied.)
Clip
#10-32 Machine screw
10'
7302310-100