Whittier Wood Products Gourmet Island 203W Instrucciones De Ensamblaje página 4

N
x 28
O
x 2
2. Glue 1" Wood Dowel (O):
• One in each End Apron (D)
Glue 2" Wood Dowels (N):
• Eight in each Back Leg (A)
• Six in Left Front Leg (B)
• Six in Right Front Leg (C)
Lay out parts, making sure the dowels
are positioned as shown in FIGURE 2, to
correctly position the legs for the next step.
P
x 16
R
x 4
R
FIG. 3A
3. Attach End Apron (D) to Left Front Leg (B) gluing Wood Dowels (N). Position End Apron (D) so
that the pocket holes will be facing into the unit and the dowel in the edge of the End Apron (D)
is facing up. See FIGURE 3A. Use Screw (P) to secure the End Apron (D) in place. See FIGURE
3A.
Next, attach two Rack End Supports (E) to the Left Front Leg (B), gluing the Wood Dowels (N)
and securing with Screw (P). Make sure the pocket holes in the Rack End Supports (E) are facing
down and the supports are straight and parallel to the leg. See FIGURE 3A & 3C.
Attach the Back Leg (A) to the assembly, gluing Dowels (N) and securing with Screws (P).
4. Install Drawer Slide (Cabinet Side Left) (Q2) using Screw (R) into the small predrilled holes in the
left leg assembly. Use the first hole behind the slide wheel and the last hole on the slide. Make
sure the slide wheels face out as shown in FIGURE 3A.
5. Repeat process for remaining Back Leg (A) and Right Front Leg (C). Use Drawer Slide (Cabinet
Side Right) (Q1) when installing the drawer slide. See FIGURE 3B.
Page 4 – 203W
O
N
N
N
N
N
These edges parallel
Dowel
R
P
P
P P
P P
P P
N
N
N
N
N
N
N
N
N
FIG. 2A
N
FIG. 3C
FIG. 3B
N
N
N
N
N
N
N
N
N
FIG. 2B
The drawer slide will be stamped with an "L" for
left or an "R" for right in the center of the wheels.
Or they will be stamped on the body of the slide:
"CL" for cabinet left; "DL" for drawer left; "CR" for
cabinet right; "DR" for drawer right.
Dowel
R
P
P P
P
P
P
P
O
N
N
N
N
R
P