Movement Treadmill R4 Manual Del Propietário página 92

MAINTENANCE
COMMON FAULT AND MAINTENANCE
Problem
and Code
A - No energy
B - Security key not inserted
C - Signal cut in the electronic system
The treadmill
D - Treadmill does not start
does not work
E - Blown fuse
F - Transformer has not been installed
correctly or is defective.
G - Electrical circuit interrupted
The running
A - The running belt is not well lubricated
belt does not
move properly B - Very tight running belt
A - The running belt is slack
The running
belt is
B - The motor belt is too loose
slipping
A - The security key has fallen
The treadmill
stopped
suddenly
B - Electronic system problem
Defective keys
Malfunction
of the keys
Key does not work
E1
Loose or defective connection wire
A - Broken motor cable or motor
E2
B - Poor connection between the
motor wires and the controller or
bad controller
A - Loose or defective connection
wire or defective controller
E3
B - Speed sensor incorrectly installed
or defective
Cause
42
Solution
Connect to the wall outlet
Insert the security key correctly
Check the control panel and signal cable
Check that the on and off button is in
the correct '' ON '' position
Change the fuse
Install the transformer correctly or
replace it
Check the connecting wire and the
connecting wire terminal and connect
correctly.
Apply lubricant to the running belt
Adjust the running belt tightness
Adjust the running belt tightness
Adjust the engine belt
Insert the security key correctly
Request technical assistance
Key changes
Change keyboard and wiring. Swap
platePCB and computer.
Connect correctly or change the wire
between the console and the controller.
Change the engine
Check and reconnect the cables or
change the controller
Connect motor wiring correctly or
replace controller
Install the speed sensor correctly or
replace the speed sensor