Technical Characteristics - LAVAZZA BLUE LB 1100 Instrucciones De Empleo

Problem
The machine does not turn on.
The LEDs flash quickly.
The capsule loading arm does not
reach the locking position.
The pump does not start.
The machine does not brew coffee.
The coffee is not hot enough.
The coffee flows too quickly, no
cream forming for the espresso.
No milk or cappuccino froth.
No hot water or steam dispensing.
For problems not covered in the above table or if the suggested solutions do not solve the problems, contact
· Power supply: : 220-240 V / 50-60 Hz
· Nominal power: 1000 W
· Water tank capacity: 1800 cc
· Weight: 8,7 kg
SOLUTIONS FOR COMMON PROBLEMS
Possible causes
» Machine not connected to the
mains.
» There is a failure.
» The used capsule drawer/drip
tray is full.
» Capsule inserted incorrectly.
» No water in the tank.
» Capsule not inserted.
» Operating temperature not
reached.
» Capsule loading arm lifted.
» No water in the tank.
» Filter not correctly inserted.
» The coffee cups are cold.
» A large amount of hot water was
dispensed.
» An already used capsule was
introduced.
» The milk is not good.
» The milk is not cold enough.
» Steam dispensing wand clogged.
» Steam/hot water spout clogged.
» No water in the tank.
» Filter not correctly inserted.
the Lavazza customer service.

TECHNICAL CHARACTERISTICS

For the technical characteristics, refer to the data plate on the machine.
Solutions
» Check the correct jack input.
» Contact the customer service or the service
centre.
» Empty the used capsule drawer/drip tray.
» Lift the capsule loading arm and insert cor-
rectly the capsule.
» Fill with fresh drinking water and repeat the
loading of the hydraulic circuit.
» Insert the capsule.
» Wait until it reaches the proper temperature.
» Lower the capsule loading arm.
» Fill with fresh drinking water and repeat the
loading of the hydraulic circuit.
» Check the insertion of the Brita® filter and
repeat the loading of the hydraulic circuit
(see instructions provided with the filter).
» Preheat the coffee cups by dispensing hot
water.
» Wait at least 20 seconds after dispensing
hot water.
» Insert a new capsule.
» Use fresh, partially skimmed milk.
» Use milk at refrigerator temperature.
» Clean the steam wand with a needle and
clean the spout.
» Clean the spout (see maintenance and
cleaning). If the problem persists, clean
the hole of the dispensing unit with a fine
needle, making sure it s not clogged, then
turn on the machine and dispense a small
amount of steam.
» Fill with fresh drinking water and repeat the
loading of the hydraulic circuit.
» Check the insertion of the Brita® filter and
repeat the loading of the hydraulic circuit
(see instructions provided with the filter).
· Materials used for the body: ABS
· Size: Height 36,5 cm - Width 27,5 cm - Depth 29,0 cm
2006/42 CE – 2004/108 CE – 2006 /95 CE
EN
19