Installation; Positioning Of The Portioning Machine; Equipment Hook-Up; Electrical Connection - ChefLine CHSP340 Manual De Instrucciones

5

INSTALLATION

Installation must be carried out by qualified personnel in compliance with local, national and European
regulations.
5.1

POSITIONING OF THE PORTIONING MACHINE

Ensure that the bearing surface is placed on a flat support surface with a suitable carrying capacity.
After unpacking the machine, put it in the prepared location, keeping in mind the minimum distances (see
point 4.2) to be respected. Remove any polystyrene protections and take off the protecting film; avoid
using tools which might damage the surfaces.
5.2

EQUIPMENT HOOK-UP

5.2.1

ELECTRICAL CONNECTION

The equipment is delivered ready for operation at the voltage indicated on the data plate.
-
The device is equipped with a flexible cable for connection to the power line of the type with
-
rubber insulation H07RN-F and section as per the machine's "technical data".
The machine's electrical equipment must be connected to a neutral conductor (N) if supplied
-
at 380 to 400 V.
-
Ensure that the voltage and the power network are adequate to provide the required
Kilowatts as per the machine's "technical data". The connection to the electrical line is
possible only if there is a main switch between the mains and the machine, in compliance to
applicable regulations, with a contact apparatus of at least 3 mm per pole. In addition, the
supply voltage when the machineis running, must not deviate from the value of the rated
voltage of ± 10%
!
The main switch should be located near the machine and should be easily
accessible.
5.2.2

GROUNDING

It is mandatory that the electrical system is equipped with an earth connection.
In compliance with current regulations, the equipment must be connected to an equipotential system
whose efficiency must be correctly assessed according to applicable standards . The connection is made
on a specific terminal located to the side of the black terminal block, with a cable with a minimum section
of 10mm 2 . The equipotential symbol is showed in the following figure:
38