Operating Instructions - Kobalt SGY-AIR141 Manual De Instrucciones

OPERATING INSTRUCTIONS

1. How to install/tighten threaded fasteners.
Push the switch (D) forward and have the
arrow on the switch (D) pointing at the arrow
on the back housing as shown. Press the
trigger (C). The tool anvil (B) runs clockwise.
(See Figure 1)
2. How to remove/loosen threaded fasteners.
Push the switch (D) backward and have the
arrow on the switch (D) pointing at the dot on
the back housing as shown. Press the trigger
(C). The tool anvil (B) runs counterclockwise.
(See Figure 2)
NOTE This tool features a power regulator valve.
Turn the switch (D) slowly forward and three
clicks will be detected. The three clicks do not
denote a specific power output but are only for
reference. The first click stands for the least
amount of power, which is suitable for just
mounting threaded fasteners on workpiece. The
third click stands for the most amount of power,
which is for tightening threaded fasteners on
workpiece. This tool operates in maximum power
in reverse, which releases threaded fasteners
from workpiece with ease. Choose the correct
torque needed on workpiece when mounting or
releasing threaded fasteners by understanding
the reference torque listed below. (See Figure 3)
Setting Torque in Forward
1st Click 30 ft-lbs (+/- 10%)
2nd Click 160 ft-lbs (+/- 10%)
3rd Click 200 ft-lbs (+/- 10%)
Torque in Reverse
220 ft-lb (+/- 10%)
11
1
2
3