Dremel 670 Traducción De Las Instrucciones Originales página 14

ALWAYS BE SURE THAT HANDS OR FINGERS DO NOT
!
INTERFERE WITH THE FREE MOVEMENT OF THE LOWER
GUARD.
Maintain a firm grip. Never force the rotary tool. Use light and continuous
pressure.
When cutting across the grain, the fibers of the wood have a tendency to
tear and lift. Advancing the saw slowly minimizes this effect.
CLEAN LOWER GUARD FREQUENTLY TO ASSURE A RAPID
!
RETURN OF LOWER GUARD.
THIS ATTACHMENT IS NOT INTENDED FOR ABRASIVE CUT OFF
!
WHEELS. STANDARD DREMEL WHEELS WILL NOT FIT ON
MANDREL.
CUTTING LARGE SHEETS
Large sheets and long boards sag or bend, depending on support. If you
attempt to cut without leveling and properly supporting the piece, the blade
will tend to bind, causing KICKBACK and extra load on the rotary tool.
Support the panel or boards close to the cut, as shown in
you cut through the sheet or board only and not the table or work bench.
The two-by-fours used to raise and support the work should be positioned
so that the broadest sides support the work and rest on the table or bench.
Do not support the work with the narrow sides as this is an unsteady
arrangement. If the sheet or board to be cut is too large for a table or work
bench, use the supporting two-by-fours on the floor and secure.
When ripping always use a straight edge guide. This improves the accuracy
of cut and reduces the chance of blade binding.
TOOL LUBRICATION
Your saw attachment has been properly lubricated and is ready to use.
MAINTENANCE
14
A a
. Be sure that
A s