Kohler K-72218 Guía De Instalación Y Cuidado página 5

Ø 3" (76 mm)
Min
Supply
Hose
2. Connect the Hoses
CAUTION: Risk of restricted waterflow and product damage.
Supply hoses must not be taut, kinked, or twisted during
installation. If the supply hoses must be coiled, maintain an inside
diameter of 3" (78 mm).
Connect the Supplies
Assemble the outlet hose to the faucet.
Connect and tighten the supply hoses to the supply stops.
Place a bucket under the outlet hose.
Turn on the water supplies.
Flush hot and cold water into a bucket for 1 minute to remove
any debris.
Connect the Spray Hose
NOTICE: The weight must be installed onto the spray hose to act
as a pull stop and prevent kinking damage.
Slide the weight, then the clamp onto the spray hose.
Kohler Co.
Solenoid
Outlet Hose
Clamp
Weight
5 1186051-2-D