Cleaning And Maintenance - Ferm AGM1086 Traducción Del Manual Original

Removing
• Loosen the auxiliary grip (6) from the mounting
hole (13).
USE
Switching on and off (fig. A)
• To switch on the machine in continuous mode,
slide the on/off switch (1) in the direction of the
grinding disc.
• To switch off the machine, press the lower part of
the on/off switch (1).
Hints for optimum use
• Clamp the workpiece. Use a clamping device for
small workpieces.
• Draw a line to define the direction in which to
guide the grinding disc.
• Hold the machine with both hands.
• Switch on the machine.
• Wait until the machine has reached full speed.
• Place the grinding disc on the workpiece.
• Slowly move the machine along the pre-drawn
line, firmly pressing the grinding disc against the
workpiece.
• Do not apply too much pressure on the machine.
Let the machine do the work.
• Switch off the machine and wait for the machine
to come to a complete standstill before putting the
machine down.

CLEANING AND MAINTENANCE

Before cleaning and maintenance, always
switch off the machine and remove the
mains plug from the mains.
• Regularly clean the housing with a soft cloth.
• Keep the ventilation slots free from dust and dirt.
If necessary, use a soft, moist cloth to remove
dust and dirt from the ventilation slots.
Only use sharp and undamaged grinding
discs.
Carbon brushes
If the carbon brushes are worn, the carbon
brushes must be replaced by the customer service
department of the manufacturer or a similarly
qualified person.
8
WARRANTY
Consult the enclosed warranty terms.
ENVIRONMENT
Disposal
The product, the accessories, and the
packaging must be sorted for
environmentally friendly recycling.
Only for EC countries
Do not dispose of power tools into domestic waste.
According to the European Guideline 2012/19/
EU for Waste Electrical and Electronic Equipment
and its implementation into national right, power
tools that are no longer usable must be collected
separately and disposed of in an environmentally
friendly way.