Kohler Sterling NI3100 Serie Manual Del Usuario página 8

4. Install Flat Panel
CAUTION: Risk of property damage. Select panel adhesive recommended for use with polystyrene
surfaces. This will ensure that the flat panel will properly adhere to the walls to create a watertight
seal.
NOTICE: Do not throw the shipping carton away. The shipping carton will be used to make a template to
drill holes for the plumbing fixtures.
NOTICE: Do not install both fixed panels at the same time. Do not install the flat panel to the plumbing
fixture side until instructed to do so.
NOTE: Plumbing fixtures can be mounted on either the left or right side of the wall surround. The
illustration above shows the wall surround with plumbing fixtures on the left.
Remove one flat panel from the shipping carton.
Place the flat panel down on a drop cloth with the dull finish side facing up.
NOTICE: Do not apply the panel adhesive to the glossy side. The panel adhesive must be applied to the
dull finish side. If the panel adhesive is accidentally applied to the glossy side, do not scrape it off.
Instead, immediately remove the panel adhesive with mineral spirits or paint thinner.
Apply a continuous bead of panel adhesive 1/4" (6 mm) thick at least 1/2" (1.3 cm) in from all four
edges of the fixed panel.
Apply diagonal beads of panel adhesive in an "X" pattern on the fixed panel, as illustrated.
With the dull side facing the wall, place the flat panel on the wall where plumbing fixtures will not
be mounted.
Place the bottom edge of the flat panel flush against the ledge of the shower receptor and the side
edge of the flat panel aligned with the front edge of the receptor.
Firmly press the flat panel against the finished wall to transfer the panel adhesive.
Using a soft cloth, apply pressure and rub the entire flat panel surface. This will ensure a secure
bond.
1034047-2-G
Flat Panel
1/2"
(1.3 cm)
Apply panel
adhesive to
the dull side.
8 Sterling