To Remove/Replace Neckroll - Arai Helmet 2012 Manual De Instrucciones

q w
e
q
r
w
26
To replace the right chinstrap cover (long side), ensure the cap side
of the chinstrap end snap (Arai logo impressed) on the chinstrap and
the leatherette side of the chinstrap cover both face outward, slip the
chinstrap cover onto the chinstrap.
Position the plastic chinstrap anchor cover over the steel anchor and push
the cover in the anchor until the tab on the back of the cover snaps fully
home.

TO REMOVE/REPLACE NECKROLL

e
RX-7GP / CORSAIR-V / QUANTUM-ST / RX-Q / SIGNET-Q
First remove the cheekpads as per previous instructions.
To remove the neckroll, pull out the neckroll end tabs, which are inserted
into the chin center pad at both sides. Grasp center of the neckroll firmly,
r
rotate it to either direction by 3cm – 4cm (1-1/4" – 1-1/2") and remove it
from the helmet.
To wash the neckroll, put it into lukewarm water with small amount of
laundry soap or your own shampoo and wash gently by hand. Rinse well
with fresh water and wipe off with a soft cloth. Dry it in the shade at
ambient temperature.
WARNING:
Never use petrol, thinner, benzene or any other solvents.
To replace the neckroll, insert the neckroll frame into the slot of the
helmet, centering the neckroll on the helmet. Further insert the frame so
that the 3 tabs on the frame are locked in the slot of the helmet.
Replace the neckroll end tabs, and replace the cheekpads
English