Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Rider will not mulch grass
1.
Wet grass
•
Do not mulch when grass is wet
2.
Excessively high grass
•
Mow once at a high cutting height,
then mow again at desired height or
make a narrower cutting swath
3.
Dull blade
•
Sharpen or replace blade
Tractor stopped or will not start
1.
Electrical system fault
•
Shut off and restart tractor
•
If problem persists, contact an
authorized service dealer
The blades do not rotate /blades stopped
1.
Overload
•
Allow deck motor(s) to cool/raise
deck height
2.
Low battery
•
Return home, plug into charger
The blade(s) stopped when traveling in reverse
1.
Blade(s) stopped
•
Restart blade(s) (PTO)
•
Make sure Reverse Caution Mode is
activated
Reduced Speed
1.
Low battery
•
Charge battery as instructed in the
battery charger manual
2.
Overload
•
Raise deck
LCD Screen Messages
Brake Switch Fault: The deck and drive shut off.
Power off and restart rider. If problem persists
contact qualified service personnel.
Accelerator Pedal Sensor Fault: The deck and
drive shut off. Power off and restart rider. If problem
persists contact qualified service personnel.
Notes
Seat Switch Fault: The deck and drive shut
off. Power off rider, sit in seat and restart rider.
If problem persists contact qualified service
personnel.
Cutting Deck Overload: The deck and drive shut
off. Power off the rider, clean under the deck as
instructed in the Post-Operation Rider Care section
and restart the rider. If problem persists contact
qualified service personnel.
Drive Motor Over Current Fault: The deck and
drive shut off. Power off, let the rider cool and
restart rider. If problem persists contact qualified
service personnel.
Drive Motor Control Fault: The deck and drive
shut off. Power off and restart rider. If problem
persists contact qualified service personnel.
Self Test Fault: The deck and drive shut off. Power
off and restart rider. If problem persists contact
qualified service personnel.
Electrical Faults: The deck and drive shut off.
Power off and restart rider. If problem persists
contact qualified service personnel.
Battery Temperature Low: Move the rider to
a warm location and allow the battery to warm.
If problem persists contact qualified service
personnel.
High Temperature Faults: Power off, let the rider
cool and restart rider. If problem persists contact
qualified service personnel.
Charge Port Door is Open: The rider will come to
a stop and shut off. Close the charge port door and
restart rider. If problem persists contact qualified
service personnel.
Low Battery Warning: The battery is low and
should be charged as soon as possible.
Sharpen Blade Warning: When this warning
is displayed, the blades should be checked and
sharpened.
Check Tire Pressure Warning: When this warning
is displayed check and adjust the tire pressure.
S
4 — P
ection
roduct
c
17
are
Publicidad
Capítulos
Tabla de contenido
