Operating Principle - Meta System ActivePark4/14 Manual De Instrucciones

EN
The product is an electronic device conceived to park the vehicle easier.
This system has been designed for application on the front or rear bumper of the vehicle.
The front system requires the push button (Y) supplied in the kit, to be connected to the slot 3 of the control unit
(general diagram on page 13).
The parking sensor is based on the principle of the sound wave refl ection when an obstacle is detected.
Knowing the speed at which sound propagates in the air and measuring the time that elapses between the emission
of a sequence of pulses and its reception, after it has been refl ected by an obstacle, it is then possible to calculate the
distance of the obstacle itself from the sound energy source (sensor).
For this purpose, there are 4 sensors allowing to completely protect the vehicle's surfaces.
Each sensor consists of an ultrasounds capsule that also acts as a receiving element of the refl ected wave.
An intermittent beep warns about the approaching of the vehicle to an obstacle.
The nearer the car gets to the obstacle the faster the beeping becomes, until turning into a continuous sound when
the minimum safety distance is reached.
Kit contents ..........................................................................................................................................Pag. 12
Installation tools ................................................................................................................................Pag. 12
General wiring diagram ..................................................................................................................Pag. 13
Technical features ..............................................................................................................................Pag.13
Painting the capsules and the relevant supports ....................................................................Pag. 13
General recommendations before starting the installation ................................................Pag. 14
Sensors fi xing positions .....................................................................................................................Pag. 14
Programming ........................................................................................................................................Pag. 17
Masking procedure .............................................................................................................................Pag. 17
Reducing the system's performance ............................................................................................Pag. 18
Reducing the side sensors detection ...........................................................................................Pag. 18
System modes for the front application .....................................................................................Pag. 18
Recording the speed threshold ....................................................................................................Pag. 18
Calibration ..............................................................................................................................................Pag. 19
Additional functions ...........................................................................................................................Pag. 19
System's cut-off for trailer connection to the vehicle ............................................................Pag. 19
Diagnostics .............................................................................................................................................Pag. 20
How to use the front system ...........................................................................................................Pag. 20
How to use the rear system ............................................................................................................Pag. 20
PARKING SENSOR FOR FRONT
AND REAR APPLICATIONS

OPERATING PRINCIPLE

- Installation with the ISH system (Internal Sensor Holder) ......................................Pag. 15
- Installation with the ESH system (External Sensor Holder) .....................................Pag. 16
-
Car stereo mute (for front and rear systems, activated through the push button)
INDEX
11
.........Pag. 19