General Wiring Diagram; Technical Features; Painting The Capsules And The Relevant Supports - Meta System ActivePark4/14 Manual De Instrucciones

SPEEDOMETER SIGNAL
Page 18
REDUCTION OF
SENSITIVITY
Page 18
Page 19
IN CASE OF INSTALLATION ON A REAR BUMPER, CONNECT THE RED AND GREY WIRES TOGETHER
Fig. 1
Power ..............................................................................................................12 Vcc (10V-15V)
Current absorption with the system active ........................................................< 50mA

PAINTING THE CAPSULES AND THE RELEVANT SUPPORTS

Fig. 2a
Before assembling the components of the sensors it is advisable to paint the capsules and supports in the same colour of the car.
Use the carton mask, included into the kit, for painting in order to prevent paint from getting on parts of the capsule which would
alter its performance.
Specifi c primers must be applied fi rst before painting; make sure the paint is completely dry before assembling the components.

GENERAL WIRING DIAGRAM

GREEN/BLACK
FRONT INSTALLATION
RED
GREY
BLACK
REDUCTIONS OF
PERFORMANCE
RED/DARK BLUE
YELLOW
PURPLE BROWN

TECHNICAL FEATURES

Fig. 2b
OFFSET
SOUND
SENSITIVITY
ACCESSORY
OPT: ABP05580
SYSTEM'S
Page 18
READING
MASKING
Page 17
Page 19
13
Page 19
Left side
of bumper
YELLOW
LIGHT BLUE
WHITE BLACK
Right side
of bumper