Canon 102 Guia De Instalacion página 18

000-FlatbedScannerUnit102_SG_EN.book Page 7 Sunday, December 11, 2016 4:01 AM
■ Do not place objects on the flatbed. The objects may fall over or off
of the flatbed, resulting in personal injury.
■ Connect the AC adapter only to a power outlet of the rated voltage
and power supply frequency (120 V, 60 Hz or 220-240 V, 50/60 Hz
depending on your region).
■ When unplugging the power cord, grasp it firmly by its power plug.
Do not pull directly on the power cord, as this may damage or
expose the cord's internal wiring, resulting in a fire or electric shock.
■ Leave sufficient space around the power plug so that it can be
disconnected easily. If objects are placed around the power plug,
you will be unable to disconnect it in an emergency.
■ Do not allow water or flammable substances (alcohol, paint thinner,
benzene, etc.) to spill onto the flatbed, as this may result in a fire or
electric shock.
■ Also, turn OFF the power switch, and disconnect the power cord
from the power outlet for safety when the machine will not be used
for an extended period of time, such as during consecutive holidays.
■ Open and close the document cover gently. Failure to do so may
result in a malfunction or personal injury.
■ Be careful when closing the document cover to avoid pinching your
hands. Failure to do so may result in personal injury.
■ Do not press down hard on the document cover. Doing so may
result in damage to the glass, a malfunction, or personal injury.
■ Never place any object other than documents to be scanned onto
the scanning glass. Doing so may result in a malfunction or
personal injury.
■ When using the flatbed in cold temperatures, wait a few moments
after turning the power switch ON. Failure to do so may result in a
condensation error.
Disposal
When disposing the flatbed or AC adapter, make sure to follow the
local ordinances and laws or consult with your local authorized Canon
dealer or service representative.
When Sending the Flatbed for Repairs
If you need to send the flatbed out for repairs, use the packing box in
which it came. Make sure to set the lock switch at the bottom of the
flatbed to the positon to lock the scanning unit into place, and firmly
secure the flatbed with packaging material when you place it in the
packing box.
7