End Of Programming; Technical Data - Kübler CODIX 52T Instrucciones De Puesta En Servicio

4.7 Multiplying factor (totaliser 2)
It can be set from 00.0001 up
to 99.9999.
The decimal point is set to 4
decimal places. „0" is not
accepted!
4.8 Dividing factor (totaliser 2)
It can be set from 00.0001 up
to 99.9999.
The decimal point is set to 4
decimal places. „0" is not
accepted!
4.9 Decimal point (totaliser 2)
The decimal point defines the
way of displaying the count val-
ues. It does not affect counting.
0
0.0
0.00
0.000
5.0 RESET Mode (totaliser 2)
manual reset via the red
RESET key and electrical reset
via the RESET input
no reset (red RESET key and
RESET input locked)
only electrical reset via the
RESET input
only manual reset via the red
RESET key
no decimal place
one decimal place
two decimal places
three decimal places

5.1 End of programming

The programming routine is
repeated once more. The val-
ues set until now can be
checked and modified.
The programming routine wil be
left and all values set will be
stored as new parameters.
Afterwards the device is ready
for operation.

5. Technical data

Supply voltage
Power supply:
tection
Display:
Data retention:
Polarity of the inputs:
Input resistance:
Count frequency:
DC power supply: 24 V
Input level:
typ. low level:
typ. ligh level:
Fmax:*
tot.tot
* at maximum frequency square wave pulses 1:1
Minimum pulse length for the Reset input:
5 ms
Input sensitivity:
Standard sensitivity:
4 ... 30 V DC level: Low: 0 ... 2 V DC
10 ... 30 V DC/max. 55 mA
with inverse-polarity pro-
6 digits, red 7 segment
LED display, height 8 mm
EEPROM
Programmable, npn or pnp
for all inputs
appr. 5 k
12 V 10 ...30 V
Standard 5V
2,5 V 2,0 V 1,0 V
22,0 V 10 V 4,0 V
kHz kHz kHz
60 20 8
Low: 0 ... 0,2 x U [V DC]
B
High: 0,6 x U ... 30 [V DC]
B
High: 4 ...30 V DC
3