Troubleshooting - GreenWorks BLV12B00 El Manual Del Propietario

TROUBLESHOOTING

PROBLEM
Unit will not blow
or vacuum.
Unit will not start.
POSSIBLE CAUSE
1. Bag full
2. Blocked tube
3. Blocked impeller
4. Dirty bag
5. Torn bag
6. Bag unzipped
7. Unit unplugged
1. Unit is unplugged.
2. Power/speed switch is in
the OFF position.
3. Defective power switch.
4. Vac tubes are not correctly
installed.
5. Intake gate/cover is not
closed.
6. House circuit may have
tripped.
SOLUTION
1. Empty the bag.
2. Clear the blockage.
3. Clear the blockage.
4. Clean the bag.
5. Replace the bag.
6. Zip up the bag.
7. Plug into an outlet or an extension cord.
1. Check cord to make sure it is plugged
into an electrical outlet.
2. Slide switch to high or low.
3. Call toll-free helpline: 1-888-909-6757.
4. Check vac tubes to ensure that they are
allowing the switch to be engaged when
correctly installed.
5. Ensure that gate/cover is fully closed
and locked.
6. Check wall circuit breaker panel and
reset if necessary.
18