Cruise Control Lever; Operation Tips; Maintenance; Clean The Machine - GreenWorks BLF341 Manual Del Operador

EN

11.3 CRUISE CONTROL LEVER

8
1. Pull the cruise control lever (8) clockwise to increase
the speed. This will lock the speed at the desired
setting.
2. Push the cruise control lever (8) counter clockwise
to decrease the speed.
If you decrease the speed all the way, the unit will stop
and it is necessary to do the first step again.

11.4 OPERATION TIPS

• Blow around the outer edge of the unwanted
materials to prevent the unwanted materials from
scattering.
• Use rakes and brooms to clear the unwanted
material before you blow.
• Make the surfaces wet before you clear the
unwanted material in dusty conditions.
• Look out for children, pets, open windows, and
cleaned cars during operation.
•

Clean the machine.

• Discard the unwanted material when you complete
work.
12

MAINTENANCE

Do not let brake fluids, gasoline, petroleum-based
materials touch the plastic parts. Chemicals can cause
damage to the plastic, and make the plastic
unserviceable.
Do not use strong solvents or detergents on the plastic
housing or components.
1
NOTE
CAUTION
CAUTION
English
Remove the battery pack from the machine before
maintenance.
12.1 CLEAN THE MACHINE
The machine must be dry. Humidity can cause risks of
electrical shocks.
• Clear the unwanted material out of the air vent with
a vacuum cleaner.
• Do not spray the air vent or put the air vent in
solvents.
• Clean the housing and the plastic components with
a moist and soft cloth.
13 TRANSPORTATION AND
STORAGE
Remove the battery pack from the machine before
tranportation and storage.

13.1 MOVE THE MACHINE

• Only hold the machine with the handgrip.

13.2 STORE THE MACHINE

• Clean the machine before storage.
• Make sure that the motor is not hot when you store
the machine.
• Make sure that the machine does not have loose or
damaged parts. If it is necessary, do these steps/
instructions:
• Replace the damaged parts.
• Tighten the bolts.
• Speak to a person of an approved service
center.
• Store the machine in a dry area.
• Make sure that children cannot come near the
machine.
14

TROUBLESHOOTING

PROBLEM
The motor does
not start when
you pull the trig-
ger.
8
WARNING
CAUTION
WARNING
POSSIBLE SOLUTION
CAUSE
Make sure that
The battery pack
you tighlty install
is not installed
the battery pack
tightly.
in the machine.
The battery pack Charge the bat-
is out of power. tery pack.