Ego Power+ STX3800 Manual Del Operador página 21

WARNING:
position before next use to avoid serious personal injury.
ADJUSTING THE CUTTING LINE
LENGTH
The trimmer head allows the operator to
release more cutting line without stopping
the motor. As line becomes frayed or
worn, additional line can be released
by lightly tapping the trimmer head on
the ground while operating the trimmer
(Fig.13).
WARNING:
the line-cutting blade assembly. Excessive line length will cause the motor to overheat
and may result in serious personal injury.
For best results, tap the trimmer head on bare ground or hard soil. Always keep the
trimming line fully extended. Line release becomes more difficult as the cutting line
becomes shorter. Replace the line when necessary. Details please see section "LINE
REPLACEMENT".
Tips for best trimming results
(Fig.14)
◾
The correct angle for the cutting
attachment is parallel to the ground.
◾
Do not force the trimmer. Allow the
very tip of the line to do the cutting
(especially along walls). Cutting with
more than the tip will reduce cutting
efficiency and may overload the
motor.
◾
The cutting height is determined by the distance of the cutting line from the lawn
surface.
◾
Grass over 8 inches (200 mm) should be cut by working from top to the bottom in
small increments to avoid premature line wear.
Make sure that the on-off switch is placed exactly in the "OFF"
Do not remove or alter
56-VOLT LITHIUM-ION REAR-MOTOR 15" STRING TRIMMER — STX3800
13
14
Rotation
direction
Best cutting area
21