Package Contents; Product Assembly - Conceptronic Grab'n'GO CHD3NET Guia De Instalacion

ENGLISH

2. Package Contents

The following items are present in the package of the Conceptronic Grab'n'GO Network
Harddisk:
1x Grab'n'GO Network Harddisk
4x HDD Assembly screw (Not included if you bought the CHD3NET with an included
Harddisk).
1x Product Stand
1x LAN Cable
1x Power Supply, 12V
1x USB 2.0 Cable

3. Product Assembly

If you bought the Conceptronic Grab'n'GO Network Disk without a Harddisk installed, you can
follow the steps of this chapter to install your own SATA Harddisk.
Note: If you bought the Conceptronic Grab'n'GO Network disk with a Harddisk installed, you
can skip this chapter and continue with Chapter 4.
A. Remove the 2 screws from the back panel of the CHD3NET and remove the back panel from
the device.
B. Gently remove the Harddisk tray from the housing by pulling at the front panel of the
CHD3NET while holding the case.
C. Insert your SATA Harddisk gently in the Harddisk tray until it is fastened correctly on the
SATA connector of the tray.
D. Use the included screws to fasten the Harddisk to the Harddisk tray.
E. Insert the Harddisk tray back in the case.
F. Replace the back panel on the CHD3NET and fasten the back panel with the 2 screws
removed at step A.
Your CHD3NET is now assembled and ready to use. You can continue at Chapter 4 for the
hardware installation instructions.
21