ENGLISH
5.1.3 IP Configuration
At the section "IP Configuration" on the Status Screen, you can change the DHCP feature.
DHCP Server can be enabled or disabled. Please note that this feature needs to be turned off if
you have already a DHCP server within your network environment. If enabled the Conceptronic
Grab'n' GO Network disk will act as DHCP server
Press 'Apply' (3) to activate this functionality.
5.1.4 Service Information
At the section "Service Information", you can check the current status of the Samba and FTP
Service.
The Samba and FTP Service can be enabled and disabled. Select the configuration of your choice
and press 'Apply' (4) to activate your changes.
5.1.5 Disk Info & Firmware
At the section "Disk Info & Firmware", you will find information about:
Product firmware information
-
Information about the used Harddisk
-
Free Amount of Mega Bytes on Hard Disk
-
Total Size of Hard Disk (In Mega Bytes)
-
5.1.6 Language
At the section "Language", you can see the current code-table language for the file system.
Change the language to the language corresponding with the file system on your computer and
press 'Apply' (5) to activate your changes.
Note: The Language option does not change the language of the configuration interface.
26