Conceptronic Grab'n'GO CHD3NET Guia De Instalacion página 37

ENGLISH
7 Setting up a Static IP Address
If the DHCP server in the Grab'n'GO Network Disk is disabled, and you are using Static IP
Address assignment in your network, you need to change your IP Address to the range of the
Network Disk to access it. By default, the Grab'n'GO Network Disk works at the IP: 169.254.0.1
To change your settings, follow the steps below:
1. Click "Start", "Run", and enter: NCPA.CPL <ENTER>
2. Right click your Local Network connection and choose "Properties".
3. Select "TCP/IP" and choose "Properties".
4. Select the option "Use the following IP address:"
5. Enter an IP Address in the range 169.254.0.xxx (Where xxx can be between 2 ~ 254).
Set the subnet to 255.255.0.0
4
6. Enter the Default Gateway. If you have an active Internet Connection, enter the IP
Address of the Gateway. Otherwise, enter the IP Address of the Grab'n'GO Network
Disk.
7. Press "OK" to return to the General Properties. Press "OK" to save the settings.
Your computer is now ready to use with the Grab'n'GO Network Disk.
3
5
6
37
3