Conceptronic Grab'n'GO CHD3NET Guia De Instalacion página 28

ENGLISH
5.3 Maintenance
Select at the left side "Maintenance" to enter the Maintenance setup Page.
Options to select in the Maintenance setup Page:
- Firmware Upload
If there is new firmware released through the webpage of Conceptronic you can upload
o
it from this page into the Conceptronic Grab'n' GO network disk.
"Browse" (A) the location of the firmware file and press "Upload" (B) to update the
o
Network disk.
- System Reboot
After you have updated the firmware you need to reboot the device. A reboot can take
o
up to 1 minute before you can logon again.
Press "Reboot" (C) to reboot the device.
o
- Factory Defaults
You can reset the device back to factory defaults. After the reset you need to reboot the
o
Network disk again with the option 'System Reboot'.
Press "Reset" (D) to reset the device back to factory settings.
o
A B
C
D
28