Conceptronic Grab'n'GO CHD3NET Guia De Instalacion página 31

ENGLISH
5.5.1 Account List
A. Add
B. Modify
C. En/Disable
D. Delete
5.5.2 "Modify FTP Account" Menu
When a user is created and you press "Modify" (C), you will see the following screen:
1
1. Enter or change the Password of the user.
2. Save the configured Password of the user.
3. Decide if this user has Read Only or Read / Write Access
a. Read only means: the user can only download content from that folder
b. Read /Write Access means: the user can upload and download to and from the
FTP server
4. Select the folders to be shared through FTP for this user.
5. Press "Add" to put them in the sharing List
6. After all settings are made, press "Back" to return to the FTP Screen.
Note: The FTP server is using TCP port 21 by default. If you want to enable people outside
your network to logon to your FTP server, you need to open port 21 in your router
through the NAT / Virtual Server settings. The IP address in the NAT / Virtual Server
setting which is connected to port 21 must be the IP address of your Conceptronic
Grab'n' GO network hard disk. Check the documentation of your router how to setup
NAT / Virtual Server.
Add a new FTP User (Max. 5 users). Enter the Account Name (Max. 12
characters) and press "OK". When a new FTP User is created, click
"Modify" (C) to change the settings for the FTP User.
Enter the "Modify FTP Account" menu.
Enable or Disable the selected FTP User.
Delete the selected FTP User.
4
3
5
31
2
6