Conceptronic Grab'n'GO CHD3NET Guia De Instalacion página 33

ENGLISH
Note: The Conceptronic Grab'n' GO Network Hard Disk only supports FAT32 Format!
The following options are available:
1. Format
Note: After the hard disk is formatted you need to reboot the Conceptronic Grab'n' Go
network disk.
2. Sleep Time
3. Scan Disk
Note: Scanning the HDD can take some time. (Depending on the size of your HDD).
When formatting the Hard Disk all your data and partitions will be deleted.
Pressing the "Format" button will show a dialog box with the message: All
data will be lost! Are you sure to format disk now? Press "OK" to format the
Hard Drive.
When the CHD3NET is not in use, the Hard Disk can be turned off
automatically. Enter the amount of Idle Minutes before the Hard Disk turns
into idle mode (5 ~ 60 Minutes). Press "Set" to save the entered value.
After the reboot you can select the Scan Disk feature by pressing "Start".
This Scan Disk feature will check the file system. If there are any errors
found it will try to correct them. This feature should be used on a regularly
bases. The results of the Scan Disk will be shown in the column.
33