HoMedics BPW-260 Manual Del Usuario página 13

2. With the cuff wrapped around your wrist, press the
START/STOP button. Do not inflate the cuff unless
it is wrapped around your wrist. All digits will light
up, checking the display functions. The checking
procedure will be completed after about 3 seconds.
START
STOP
Note: If using the Voice Assist™ "Instructions On"
mode, you will be prompted to press the
START/STOP button again before measurement
begins.
3. After all symbols disappear, the display will show "00".
The monitor is "Ready to Measure" and will
automatically inflate the cuff to begin measurement.
The cuff will then begin deflating as measurement
continues.
BPW-260_A.indd 23-24 BPW-260_A.indd 23-24
23
Note: The monitor will re-inflate automatically if the
system detects that your body requires more
pressure for measurement.
. When the measurement is completed, the cuff
will deflate entirely and systolic pressure, diastolic
pressure and pulse will be shown simultaneously
on the LCD screen. The measurement is then
automatically stored into memory.
24
12/7/09 4:48 PM 12/7/09 4:48 PM