Date & Time Set Procedure; Using The Voice Assist™ Talking Function - HoMedics BPW-260 Manual Del Usuario

DATE & TIME SET PROCEDURE
1. To adjust the date/time, press the Set button
located on the top of the monitor.
2. The display will show a blinking number showing
the HOUR. Change the HOUR by pressing the
button. Each press will increase the number
by one in a cycling manner. Press the Set button
again to confirm the entry, and the screen
will show a blinking number representing the
MINUTE.
3. Change the MINUTE, MONTH, DAY and YEAR as
described in Step 2 above, using the
to change the numbers and the
confirm the entries.
repeat process to set MINUTE,
MONTH, DAY and YEAR
BPW-260_A.indd 15-16 BPW-260_A.indd 15-16
button
button to
Press the button
blinking HOUR
increasing HOUR
confirm the entry
15
USING THE VOICE ASSIST™
TALKING FUNCTION
The Voice Assist feature will guide you through the
measurement procedure and also announce results
after your reading. The Voice Assist™ Talking Function
is not a substitute for reading and understanding the
instruction manual.
The Voice Assist feature has 3 modes:
• Instructions On Mode - Announces instructions
and results
• Instructions Off Mode - Announces results only
• Quiet Mode - No voice
Setting the Voice Assist Mode:
1. Press the Talking mode button on the top of the
monitor. Each press of the Talking Mode button will
cycle through the different modes.
TALKING
AGE
MODE
2. When the appears with the letters "InS ON", this
indicates the monitor is in "Instructions On" Mode.
16
12/7/09 4:48 PM 12/7/09 4:48 PM