Maintenance And Cleaning - Parkside PLS 48 C1 Traducción Del Manual De Instrucciones Original

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

Place the solder (with flux) between the solder joint and solder-
ing tip to melt it.
Keep feeding in solder until the entire solder joint is covered.
Then withdraw the soldering tip immediately to prevent over-
heating the molten solder.
Allow the solder to harden and avoid vibrations.
NOTE
The flux is either included in the solder or it is applied separately.
When buying the solder ask about its use and the appropriate flux.

Maintenance and cleaning

WARNING! RISK OF INJURY! Always pull the
plug out of the socket and let the appliance cool
down before you carry out any work on the
appliance.
Always clean the appliance after completion of work.
To clean the housing, use a cloth and a mild detergent if neces-
sary.
Never use sharp objects, petrol, solvents or cleaning agents that
can damage plastic.
Do not allow any liquids to get into the interior of the appliance.
NOTE
You can order spare parts (such as solder tips) via our service
hotline.
PLS 48 C1
GB
65

Publicidad

Tabla de contenido
loading

Tabla de contenido