Displaying Stored Results - Gima KD-558 Guía De Uso

b. Then the current memory bank (U1 or U2) is blinking. See picture 6-1.
Press "MEM" button to change over to other bank. See picture 6-2.
Confirm your selection by pressing "START" button. The current bank
can also be confirmed automatically after 5 seconds with no operation.
Picture 6
c. After selecting the memory bank, the monitor starts to seek zero pressure.
See picture 6-3.
d. The monitor inflates the cuff until sufficient pressure has built up for a
measurement. Then the monitor slowly releases air from the cuff and
carries out the measurement. Finally the blood pressure and pulse rate
will be calculated and displayed on the LCD screen separately. Irregular
heartbeat symbol (if any) will blink. See picture 6-4&6-5. The result will
be automatically stored in the current memory bank.
Picture 6-3
e. After measurement, the monitor will turn off automatically after 1 minute
of no operation. Alternatively, you can press the "START" button to turn off
the monitor manually.
f. During measurement, you can press the "START" button to turn off
the monitor manually.
Note: Please consult a health care professional for interpretation of pressure
measurements.

7. Displaying stored results

a. After the measurement, you can review the measurements in the current
memory bank by pressing button "MEM". Now the LCD displays the
amount of the results in the current bank. See picture 7.
ENGLISH
Picture 6-1
Picture 6-4
Picture 6-2
Picture 6-5
30