Setup And Operating Procedures; Battery Loading; Clock And Date Adjustment - Gima KD-558 Guía De Uso

Ocultar thumbs Ver también para KD-558:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 59
27
16. This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.

SETUP AND OPERATING PROCEDURES

1. Battery loading

a. Open battery cover at the back of the monitor.
b. Load four "AA" size batteries. Please pay attention to polarity.
c. Close the battery cover.
When LCD shows battery symbol
Rechargeable batteries are not suitable for this monitor.
Remove the batteries if the monitor will not be used for a month or more
z
to avoid relevant damage of battery leakage.
Avoid the battery fluid to get in your eyes. If it should get in your eyes,
immediately rinse with plenty of clean water and contact a physician.
Σ
IVD
1
The monitor, the batteries and the cuff, must be disposed of according
to local regulations at the end of their usage.
PHTHALATES

2. Clock and date adjustment

a. Once you install the battery or turn off the monitor, it will enter Clock
Mode, and LCD will display time and date by turns. See picture 2&2-1.
ENGLISH
, replace all batteries with new ones.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

32921

Tabla de contenido