Operating Conditions - BONFIGLIOLI ACTIVE CUBE Guia De Inicio Rapido

 After one year of storage, connect the device to mains voltage for 60
minutes.
1.4 After unpacking
 Check if the delivered devices corresponds to the order.
 Check the device for transport damage and completeness.
GB
 Report any defects/damage to the supplier immediately.
1.5 Place of installation
 In rooms without weather exposure.
 Avoid direct sunlight exposure.
 Avoid dust.
 Keep away from strong electromagnetic fields.
 Keep away from combustible material.
 Provide sufficient cooling. Install fans when installing the frequency
inverter inside an enclosed cabinet.
 Altitude of installation: ≤ 4000 m, above 1000 m with reduced power
(reduced output current).
 Ingress protection rating of frequency inverter: IP20. Use of the device in
explosive atmospheres is not permitted.
 The frequency inverter produces noise. For this reason it should be
installed in areas where usually people do not stay for a long time.
 Noise emission in operation is < 85 dB(A) in the case of sizes 1 through 7.
 Noise emission in operation is approx. 86 dB(A) in the case of size 8. Use
ear protectors when staying near the frequency inverter.

1.6 Operating conditions

 Size 1...7:
o Ambient temperature: 0...55°C, as from 40°C, power reduction of
2.5% / K should be considered.
 Size 8
o Ambient temperature: 0...55°C, as from 45°C, power reduction of
2.5% / K should be considered.
 Ambient pressure: 70 ... 106 kPa
 The frequency inverter may be operated in TN, TT and IT grid types.
Operation in a corner-grounded TN grid shall not be permissible.
 Environment specification: Pollution degree 2 and overvoltage category III
(IEC 60664-1 /DIN VDE 0110-1) up to 2000 m installation altitude. Above
2000 m installation altitude overvoltage category II.
62 Quick Start Guide ACU 10/18