Ingersoll Rand 100SQ1 Manual De Funcionamiento Y Mantenimiento página 25

14. Reinstall the Cover Assembly and use a hex wrench to
push it below the threads at the rear of the Housing.
(Refer to Dwg. TPD1290.)
PUSH DOWN
15. Install the Housing Cap (36) and using the spanner
plug furnished in the Tool Kit, tighten the Cap between
58 and 65 ft–lb (78 and 88 Nm) torque. (Refer to
Dwg. TPD1291.)
MAINTENANCE SECTION
(Dwg. TPD1290)
25
SPANNER PLUG
16. Make certain the Drive Shaft rotates freely. Install the
Mechanism Cover Spacer (51) and then fill the
mechanism with fluid and reassemble the tool as
instructed in the section, CHANGING THE
MECHANISM FLUID.
CLOCKWISE TO TIGHTEN
(Dwg. TPD1291)