KTM Power Parts 61611946044 Manual Del Usuario página 5

Scope of supply
1x retaining bracket
1x magnet holder
2x cap head screw M4x10
1x spacer, large
1x spacer, small
This side stand removal kit has not been homologated and
therefore does not have offi cial approval for road service. The
customer must check with the national regulatory authorities to
establish whether, where required, individual type approval or
a full homologation of the particular vehicle with the PowerPart
installed is guaranteed in the planned country of use.
Preliminary work
- Raise the rear of the motorcycle using lifting gear (see Owner's
Manual).
Assembly
- Remove screws .
- Take off the engine sprocket cover.
- Remove screws .
- Take off side stand with protective plate and hang side stand to the
side.
- Remove screws .
- Take off side stand.
- Remove screws .
- Remove screw .
- Take off side stand bracket.
- Remove cable tie.
- Remove side stand bracket.
5