Installation; Tube Preparation; Motor/Tube Assembly - SOMFY JUNIOR RU 30 RTS Instrucciones

Safety warning!

2. INSTALLATION

Instructions which must be followed by the motor and home automation professional installing the motor.
Never drop, knock, drill or submerge the motor.
Install a separate control point for each motor.
2.1. INSTALLATION
2.1.1. Preparing the motor
Check that the inner diameter of the tube is greater than 30 mm.
1) Fit the accessories required to integrate the motor in the roller tube:
• Fit the crown a, the motor wheel b and the stop wheel c on the motor.
2) Measure the length (L) between the inner edge of the motor head and the center
of the motor wheel.

2.1.2. Tube preparation

1) Cut the roller tube to the required length, depending on the motorised product.
2) Deburr the roller tube and remove the swarf.

2.1.3. Motor/tube assembly

1) Slide the motor into the tube.
Insert the wheel by aligning the wheel to the tube profile. Insert the motor half way
and then slide the crown down the motor and insert it in the tube. Finally, push the
motor inside the tube.
2) Not required, but if needed, fix the tube to the motor with self-tapping screws or
steel pop rivets depending on the dimension (L).
Copyright © 2016 Somfy SAS. All rights reserved.
Caution!
Information
Images not contractually binding
1)
Ø > 30 mm
a
2)
1) 2)
1)
2)
EN
b
C
3