Wiring; Commissioning - SOMFY JUNIOR RU 30 RTS Instrucciones

EN
2.1.4. Installing the motor/tube assembly
The motorised product must not be compressed between the brackets
Install and fix the motor/tube assembly onto the end bracket f and onto the motor
bracket g:
Ensure that the motor/tube assembly is secured onto the end bracket. This opera-
tion prevents the motor/tube assembly from coming out of the end bracket mounting
when the roller blind reaches the lower end limit position.

2.2. WIRING

Cables which pass through a metal wall must be protected and isolated using a sheath or sleeve.
Attach cables to prevent any contact with moving parts.
The cable for the JUNIOR RU 30 RTS cannot be removed. If it is damaged, return the motor to the A er-Sales department.
To ensure electrical safety, this Class III drive must be powered by a «SELV» voltage source (Safety Extra Low Voltage).
Leave the motor power supply cable accessible: it must be possible to replace it easily.
Do not unplug the battery when the motor is working.
Plug the battery with the motor supply cable :

2.3. COMMISSIONING

2.3.1. Start the commissioning process
The motor has end limits and rotation direction already set.
Plug the battery to the motor supply cable (Step 2.2). The motorised product
moves up and down twice.
Quickly press the PROG button of the control points. The motorised product
moves up and down.
This control point is programmed in the motorisation.
2.3.2. Readjusting the direction of rotation
Move the motorised product away from the end limits.
1) Press the Up and Down buttons simultaneously, until the motorised
product moves up and down.
2) Press the my button, until the motorised product moves up and down, to
reverse the rotation direction.
3) Press the Up button to check the new direction of rotation.
4
Images not contractually binding
1)
g
PROG.
1)
2)
3)
Copyright © 2016 Somfy SAS. All rights reserved.
f