Tabla De Contenido; Safety Information; Electric Shock Hazard - Harbor Breeze 00723 Manual De Instrucciones

TABLE OF CONTENTS

Safety Information............................................................................................................... 3

Package Contents............................................................................................................... 4
Hardware Contents...............................................................................................................5
Preparation ......................................................................................................................... 5
Assembly Instructions ......................................................................................................... 6
Operating Instructions ........................................................................................................ 12
Care and Maintenance ....................................................................................................... 12
Troubleshooting................................................................................................................... 12
Warranty.............................................................................................................................. 13
Replacement Parts List ...................................................................................................... 13
2
SAFETY INFORMATION
READ AND SAVE THESE INSTRUCTIONS
Please read and understand this entire manual before attempting to assemble, operate or install the
product.
• When using an existing outlet box, be sure the box is securely attached to the building structure
and can support the full weight of the fan, so as to avoid potential serious injury or death.
• All wiring must be in accordance with the National Electrical Code "ANSI/NFPA 70-1999" and local
electrical codes. Electrical installation should be performed by a qualified licensed electrician.
• Electrical diagrams are for reference only.
• Do not use bulbs that have a wattage greater than the maximum value stated on the fixture and
in this manual. Using a higher wattage bulb than specified will increase fixture temperature and
cause risk of fire. Disconnect the electrical supply circuit to the fan before installing light kit.
• After making the wire connections, the wires should be spread apart with the grounded conductor
and the equipment-grounding conductor on one side of the outlet box and the ungrounded
conductor on the other side of the outlet box.
• Splices after being made should be turned upward and pushed carefully up into the outlet box.
• All set screws must be checked and retightened during and before installation.
• The net weight of this fan including the light kit is: 26.4 lbs.
WARNING
• ELECTRIC SHOCK HAZARD - To reduce the risk of electric shock, do not use this fan with
any solid-state speed control device.
• ELECTRIC SHOCK HAZARD - To reduce the risk of electric shock, make sure the electricity
has been turned off at the circuit breaker or fuse box before beginning installation.
• PERSONAL INJURY HAZARD - To reduce the risk of injury to persons, install fan so that the
blade is at least 7 ft. above the floor.
• FIRE, ELECTRIC SHOCK OR PERSONAL INJURY HAZARD - To reduce the risk of fire,
electric shock, or personal injury, mount to an outlet box marked "ACCEPTABLE FOR FAN
SUPPORT OF 35 lbs OR LESS" and use the mounting screws provided with the outlet box.
Most outlet boxes commonly used for the support of lighting fixtures are not acceptable for fan
support and may need to be replaced. Consult a qualified licensed electrician if in doubt.
• PERSONAL INJURY HAZARD - Reduce the risk of personal injury, do not bend the blade
brackets when installing the brackets, balancing the blades or cleaning the fan. DO NOT insert
foreign objects in between the rotating fan blades.
3