Installation And Mounting - Cameo ROOT PAR Manual De Usuario

(Brightness)
Set the overall brightness in 6 steps. Press this button several times (Step 1 = blackout) to access
the different brightness levels.
FL (Flash/Strobe)
Speed setting for the strobe effect in 6 steps. Step 1 deactivates the strobe effect, step 2 produc-
es a slow frequency followed by steps 3 to 5. Step 6 produces the fastest flash frequency. The
strobe effect can only be used in RGBW color mixing mode.
R / G / B / W
Individual color mixes can be created using these 4 buttons. The 6 brightness levels can be
accessed by pressing the respective color button again, where level 1 means that the LEDs are
switched off. Example: If you set red and green to their respective maximum levels and the other
LEDs to their lowest (off), then you will have a color mix of light yellow.
Ju (Color change)
The color changes rapidly (color jumping). The color-changing speed can be set with the SP
button (Speed).
Fa (Fade)
Colors fade into each other (color fading). The color-changing speed can be set with the SP button
(Speed).
Au (Automatic mode)
Repeatedly press the Au button to select the desired color change program Auto 1–6.
Su (Music-controlled color change programs)
Repeatedly press the Su button to select one of the 6 music-controlled programs Sound 1–6. The
control microphone is located on the back of the spotlight.
CM (Color macros)
Use the CM+ and CM- buttons to successively access fifteen color presets.
Pr+/Pr-
Select programs in automatic mode (Au) and in music control (Su).
INSTALLATION AND MOUNTNG
Thanks to its convenient double bracket, the lamp can be positioned in a suitable location on a
level surface. Installation on a traverse is possible with a traverse clamp, which is attached to the
mounting bracket (A). Suitable traverse clamps are optionally available. Ensure firm connections
and secure the spotlight by attaching a suitable safety cable to the securing lug on the back of the
spotlight.
21