Temperature Unit; Setup And Installation - Cameo STUDIO PAR TW Manual De Usuario

SYSTEM INFORMATION (System Info)
Starting from the main display, press MODE to enter the main menu. Now use UP and DOWN to
select the menu item System Info and confirm with ENTER.
Menu
DMX Address
DMX Mode
DMX Delay
Stand Alone
Slave
Settings
System Info
This will take you to the submenu for accessing the system information (see table, selection with
UP and DOWN, confirm with ENTER, change status with UP and DOWN, confirm with ENTER).
System Info
Firmware = Displays device firmware Software
Temperature = Displays temperature of
LED unit
Op Hours = Displays operating time

SETUP AND INSTALLATION

HAZARD: Overhead mounting requires extensive experience, including the calculation of
the load limit values of the installation material and regular safety inspection of all
installation materials and spotlights. If you do not have these qualifications, do not
attempt to perform an installation yourself. Refer instead to a qualified professional.
There is a risk that devices that are incorrectly mounted and secured may come loose
and fall down. This can cause serious injury or death.
V1.xx
Temperature xxx °C / xxx °F
Temperature °C (= display in degrees Celsius)
unit
°F (= display in degrees Fahren-
heit)
Op Hours Displays total operating time in
xxxx:xxh hours and minutes
21