Pentair FRESHPOINT F3000-B2B Manual De Instalación Y Funcionamiento página 5

INSTALLATION CONTINUED
3. Mounting the Faucet
A. Apply 3-5 wraps of plumber's tape to faucet stem.
B. Assemble faucet as shown in Figure 3.
C. Screw quick connector onto threaded end of faucet stem.
D. Place a mark 5/8" from one end of the blue tubing. Wet the
end of the 3/8" tube and push into bottom of connector. The
5/8" mark should be flush with the collar of the connector.
NOTE: To remove the tube, push on the fittings' collar and pull
the tube out.
E. Holding the faucet, feed the tubing through the hole in the
sink. Position the faucet handle at a desired location.
F. Center the faucet and slip slotted disc between the bottom
of the counter or sink and lock washer. Tighten the stem
nut with a wrench until it is tight.
G. Firmly insert spout into faucet base.
4. Mounting the System
A. Select a location under the sink, or other suitable area
where the system will be installed.
NOTE: The system carton can be used to determine the
operational footprint required for installation of the
system and replacement cartridges. (Figure 4a)
B. Mount the system vertically. Ensure mounting is level.
Place a pencil mark in the upper slots of the bracket
mounting holes. (Figure 4b). Alternate mounting option: If
mounting the system near the floor, place the pencil marks
above each of the mounting holes on the bracket to ensure
enough space resides below the cartridge and the floor for
cartridge replacement (Figure 4c). Use the 3/32" drill bit to
create pilot holes for mounting.
The system should be mounted to a firm, solid
WARNING:
surface that is able to support the weight of the
system.
4b
4c
3
Faucet Stem
Chrome
Plate
Rubber
Washer
Slotted
Disk
Lock Washer
Stem Nut
Quick
Connector
3/8" Tubing
4a
16.25" (413 mm)
Filter
Filter
FRESHPOINT F3000-B2B, F3000-B2M Filtration Systems Instruction Manual • 5
Counter Top
7" (178 mm)
Inlet
14" (356 mm)
Outlet