Connecting The Hob To The Mains Power Supply - EAS ELECTRIC EMIH290-3S Manual De Instrucciones

Ocultar thumbs Ver también para EMIH290-3S:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Under any circumstances, the brackets cannot touch with the inner surfaces of the worktop after
installation (see picture)
9.6 Cautions
1. The induction hotplate must be installed by qualified personnel or technicians. We have
professionals at your service. Please never conduct the operation by yourself.
2. The hob will not be installed directly above a dishwasher, fridge, freezer, washing machine or
clothes dryer, as the humidity may damage the hob electronics
3. The induction hotplate shall be installed such that better heat radiation can be ensured to enhance
its reliability.
4. The wall and induced heating zone above the table surface shall withstand heat.
5. To avoid any damage, the sandwich layer and adhesive must be resistant to heat.
6. A steam cleaner is not to be used.

9.7 Connecting the hob to the mains power supply

This hob must be connected to the mains power supply only by a suitably qualified persol
Before connecting the hob to the mains power supply, check that:
1. The domestic wiring system is suitable for the power drawn by the hob.
2. The voltage corresponds to the value given in the rating plate
.
24
V.2

Publicidad

Tabla de contenido
loading

Tabla de contenido