Installation Instructions; Space Requirements - mabe RMC090NESY0 Instructivo

20

Installation instructions

Warning: Use two or more people to move the refrigerator.
failure to do so, could result in back injuries or other injuries.
• Remove tape and any labels
from your refrigerator before
using (except the rating label).
To remove any remaining tape
or glue, rub the area briskly with
your thumb.
Tape or glue residue can also be
•
easily removed by rubbing a
small amount of liquid dish
soap over the adhesive with
your ngers. Wipe with warm
water and dry.
•
Do not use sharp instruments,
rubbing alcohol, ammable
uids, or abrasive cleaners to
remove tape or glue. These
products can damage the
surface of your refrigerator.
cleaning before using the unit
After you remove all packaging materials, clean the inside of your
refrigerator.

space requirements

Warning: keep ammable materials and vapors such as
gasoline, away from the refrigerator. Failure to do so, could
result in death, explosion, re or burns.
•
To ensure proper ventilation for
your refrigerator, allow 200 mm
space on each side between
walls,100 mm space between
back of your refrigerator and the
wall, and 300 mm space above
the top.
When moving the refrigerator,
•
do not tilt it at an angle larger
than 45° from its upright
position.
•
If you are installing your
refrigerator next to a wall,
leave su cient space on the
hinge side to allow for the
door to open.
•
Never install your refrigera-
tor near heat sources or in a
place where it will be
exposed to direct sunlight.