Installation Instructions; Materials You May Need - mabe IWO19JSPFFS Instrucciones Y Advertencias

INSTALLATION INSTRUCTIONS

MATERIALS YOU MAY NEED

(not included)
Fastening screws 6.350 mm (¼") x
38.100 mm (1 ½") hex head for
concrete and #10-16 x 38 mm
(1 ½") hex head screws for wood
Only for anti-tip supports mounted on concrete.
Drill properly for the plugs.
HOW TO LOCATE THE ANTI-TIP
2
FLOOR SUPPORT
A Inside the W space, where your refrigerator
will be located, make a small mark on the floor
attached to the back wall. This mark indicates
the desired location of the left side of the
refrigerator. From this mark measure 130 mm
to the right and place the anti-tip bracket. The
left edge of the holder must be 130 mm from
the left side of the refrigerator.
2 holes in
Floor the wall
support
to be installed
Holes on
the right
130 mm
Refrigerator
left side
Plugs (9.525 mm (3/8")
external diameter).
Floor - Concrete
(2 holes)
Floor - Wood
(2 holes)
Base support
in the
refrigerator
HOW TO LOCATE THE ANTI-TIP
2
FLOOR SUPPORT (cont.)
B
Hold the bracket in this position and use it as
a template to mark the holes based on the
configuration and type of construction, as
shown in step 3.
NOTE:
It is REQUIRED to use at least 2 screws to
mount the floor stand (one on each side
of the anti-tip floor stand). Both must be
in the wall or on the floor.
Figure 2 indicates all acceptable mounting
configurations for the screws. Identify the
screw holes in the roll-away bracket for your
configuration.
Figure 2 -Locations of
acceptable screws
Preferred Installation –
Wood
Minimum aceptable N°1 –
Wall plate support
Minimum acceptable N°3 –
Concrete floor
Preferred Installation -
Concrete
Minimum aceptable N°2 –
Wood floor
7