Publicidad
Idiomas disponibles
Idiomas disponibles
Using short carriage bolts, attach fairing to brackets
using the three most appropriate holes in fairing.
rubber washer
short bolt
FAIRING
BRACKET
rubber washer
Always keep top of fairing
•
below the top of crossbar
to avoid contact betwen
fairing and a load on the
carrier. Try to axoid more
NOTE:
washer
Place adhesive side
of rubber washers
against plastic.
wing nut
lock washer
gap than necessary be-
tween top of fairing and
bottom of crossbar to keep
air flowing smoothly over
crossbar.
Position fairing so rubber strip rests on top
of windshield rim. Fairing may also rest on
windsheild, but NEVER ON PAINTED SURFACE.
Adjust brackets and Snap Arounds until rubber
strip contacts windshield with as few "gaps" as
possible. Gaps between rubber strip and trim may
result in "fluttering" of fairing.
• In some cases it may be
necessary to bend the
brackets slightly to adjust
"angle" of bracket.
• Use warm water and dish
detergent to clean the
fairing. Abrasive cleaning
compounds will cause
scratches on the plastic.
Publicidad
