Using The Rear View Camera Functions; Setting Guidelines On The Rear View - Pioneer T1000-25815 Manual De Instrucciones

Chapter
06

Using the rear view camera functions

p The instructions in this section apply to all
models except the following:
! T1000-20494
! T1000-23345
Setting guidelines on the
rear view image
CAUTION
! When adjusting the guidelines, be sure to
park the vehicle in a safe place and apply the
handbrake.
! Before getting out of the car to place the
markings, be sure to turn the ignition switch
off (ACC OFF).
! The range projected by the rear view camera
is limited. Also, the vehicle width and distance
guidelines displayed on the rear view camera
image may differ from the actual vehicle
width and distance. (The guidelines are
straight lines.)
! The image quality may deteriorate depending
on the usage environment, such as at night or
in dark surroundings.
1 Park your vehicle in a safe place and
apply the handbrake.
2 Using packing tape or similar, place
markings approximately 25 cm from each
side of the vehicle, and approximately
50 cm and 2 m from the rear bumper.
2 m
Markings
Markings
26
Engb
50 cm
25 cm
25 cm
Rear bumper
3 Put the gearstick in reverse and display
the rear view camera screen.
4 Touch .
The screen for setting the guidelines appears.
# Each touch of
turns the guidelines dis-
play on or off.
5 Touch or
The screen for adjusting the points appears.
# If you touch [Clear], the display position of the
guidelines returns to the factory settings.
6 Touch or
7 Touch ,
the position of the point.
p When a point is moved, the distance from
the initial value is displayed at the top right
of the screen.
.
to select a point.
, or to adjust