Uat-500-T Transmitter Controls And Display; Sc-600 Signal Clamp (Optional) - Amprobe UAT-505 Manual De Usuario

2.4 UAT-500-T Transmitter Controls and Display

Transmitter Controls
1
2
3
4

2.5 SC-600 Signal Clamp (optional)

In many situations, it is either not possible to gain
access to a cable for making an electrical contact
or it is not safe to do so. The optional Signal Clamp
accessory provides an efficient and safe method
of applying a locate signal to a cable, enabling
the Transmitter to induce a signal through the
insulation into the wires or pipes. The clamp works
on low impedance closed circuits only.
1
Terminals for direct test leads connection
(de-energized systems only) and signal clamp
2
Pulse/Continuous: Press momentarily to change
between default Continuous and Pulse Modes for
better performance in high noise environments
5
3
Signal strength: Press momentarily to change
between Hi for maximum signal strength, or Lo
6
for better battery efficiency
4
Power ON/OFF: Press for 2 seconds to turn the
Transmitter ON/OFF
5
Volume: Press momentarily to change between
low, hi and mute volume levels
6
Speaker (tone indicates connection quality)
7 Battery housing cover
7
9