Klarstein 10032095 Manual Del Usuario página 29

Brewing coffee using the preset timer
Activate the display lighting by pressing any key. The lighting goes out 60 seconds after
the last button was pressed.
1 Press the Timer button (22) and keep the button pressed for about 3 seconds. The
indicator lamp (23) starts flashing.
2 Use the hour button (30) and the minute button (31) to set the required starting time.
For brewing coffee with coffee powder:
3 Also press the coffee powder button (26) while as the indicator lamp (23) is still
flashing. The indicator lamp for coffee powder (24) lights up. Fill the water tank with
water and the filter bag with coffee powder.
Brewing coffee with coffee beans:
3 Make sure that the Coffee Powder indicator lamp (24) is not on. If necessary, press
the coffe powder button (26) while the timer indicator lamp (23) is still flashing. The
indicator lamp (24) goes off.
4 Set the number of cups, the strength of the coffee and the grinding fineness.
5 Fill water into the water tank and the coffee beans into the grinder.
6 Place an unused, empty filter bag into the filter holder.
Start Timer: Press the Timer button (22) again to activate the preset timer function.
You can also wait until the indicator lamp (23) stops flashing and then press the Timer
button (22). The indicator lamp (23) lights up permanently and the time selection
function is activated. When the preset time is reached, the appliance is switched on
automatically.
Stopping the preset timer
In order to stop the timer, press one of the following buttons:
• Timer button (22) - The indicator lamp (23) goes off.
• Coffee Beans button (19) - The indicator lamp (23) goes off and the appliance
starts brewing the coffee with coffee beans.
• The Coffee Powder button (26). The Timer indicator lamp (23) goes out and the
appliance starts brewing coffee with coffee powder.
EN
29