Wall Edge Castor; Wheel Adjustment - Bona Belt UX Manual De Funcionamiento Y Mantenimiento

Machine Adjustment Procedures (Cont.)

Wall edge castor

A support with a free castor has been fitted to avoid damage to the skirting board or wall when sanding along the wall.

Wheel adjustment

Before sanding check drum operation on the work surface.
The diagram shows the two possible cases:
OK: Drum and wheels are parallel to the surface to be sanded
and the mark left by the drum is the total roller length.
If the drum operation is like in "NO" diagram, the drum and wheels must be positionated parallel to the surface to
be sanded by varying the tilt of complete wheel holder.
The wall edge castor is correctly positioned when the machine is approximately 8 mm away from the
wall with the castor up against it.
Before starting work, position the castor correctly by loosening the bolt (A),
moving the support to the required position and tightening the bolt (A).
NO: The drum does not rest fully on the surface and only
sands at one part, emphasizing marking on the floor.
EN
Bona Belt UX Manual
23