Quick Installation - Tripp-Lite SMART2500XLHG Manual Del Propietário

Quick Installation

Plug the UPS into an
1
outlet on a dedicated
circuit.
The SMART2500XLHG has an IEC C20
inlet to which the included cord set
(C19 to 5-20P) must be connected.
Attach the included power cord to the
UPS by inserting the IEC connector
the power cord into the IEC power inlet
located on the back of the UPS. Use
B
the included bracket
power cord connection.
UL 60601-1 listed UPS systems only
meet UL standard 60601-1 for medical
equipment when plugged into an NEC
517 approved and installed medical-
grade outlet.
Note: After you plug the UPS into a live AC
outlet, the UPS (in "Standby" mode) will
automatically charge its batteries,* but will not
supply power to its outlets until it is turned ON
(see Step 3 below).
* The BATTERY CHARGE LED will be the only
LED illuminated.
Plug your equipment
2
into the UPS.
Your UPS is designed to support only
electronic equipment. You will overload
the UPS if the total VA ratings for all the
equipment you connect exceeds the
UPS's Output Capacity. To find your
equipment's VA ratings, look on their
nameplates. If the equipment is listed in
amps, multiply the number of amps by
120 to determine VA. (Example: 1 amp
× 120 = 120 VA). If you are unsure if
you have overloaded the UPS's outlets,
see "OUTPUT LOAD LEVEL" LED
description.
Turn the UPS ON.
3
Press and hold the "ON/OFF/STANDBY"
button for one second. The alarm will
beep once briefly after one second has
passed. Release the button.
16-07-007-933607.indb 4
1
of
A
to secure the
C
1
2
3
4
C
B
A
8/31/2016 10:04:05 AM