JANE KOOS iSize R1 Manual Del Usuario página 26

Adjust the height of the leg (1) so that it rests on the floor of the
vehicle, the indicator on the base of the leg (9) and the indicator on the
leg adjustment button (5b) will turn green.
The COMFY base can be reclined to improve the angle of rest for the
baby. Turn the handwheel (3) to adjust the angle.
INSTALLING THE KOOS iSIZE R1 ON THE COMFY Base
Position the baby carrier so that it is fastened with the Pro-Fix anchors
intended for the KOOS iSIZE R1 (7).
Check that both sides are securely anchored, your KOOS iSIZE R1
will click when it is correctly locked in place and a green strip will be
displayed on the Pro-Fix lever (found on the handle dial).
Set the KOOS iSIZE R1 handle to the CAR position, make sure that it
is locked in place, and that the whole car symbol is displayed.
To do this, simultaneously press the release buttons found on
both sides of the handle, and set it to the position that is furthest
forward. 2 .d
Turn the handle (5) so the whole group is firmly pressed against the
vehicle backrest. 2 .e
1 .d
1
.e
2 .a
2
.b
WARNING: Your COMFY Base can be used with two different baby ca-
!
rrier models, make sure you insert the Pro-fix of your KOOS iSIZE R1
into the correct position for this model, you will find the instructions on
the platform. Once anchored, the exterior surface of the safety seat
backrest should be touching the fastening bar (9)
DETACHING THE KOOS iSIZE R1 FROM THE COMFY Base
Set the KOOS iSIZE R1 handle to the Carrying position.
Pull the release levers on both sides of the handle to release the
Pro-fix anchors and lift the baby carrier up.
To remove the platform:
2 .c
Release the ISOfix anchors by pressing the buttons (4), the signal on
the ISOfix anchor buttons will turn red.
The ISOfix anchors can be hidden inside the platform. (5)
2 .f
2 .g
2 .h
2 .i
EN
25